Ads-tec BPC1000 Bedienungsanleitung PDF herunterladen (Seite 14)

Industrial PCs BPC1000

4 COMMISSIONING

The power supply connection and interfaces of this device are installed at the device front

panel. All supply leads and all required data leads have to be connected before starting

commissioning.

Warning:

The device must be switched off before connecting or disconnecting any cables in order

to prevent damage to the electronics!

The device may only be switched on after acclimatising to the ambient temperature in

order to avoid condensate accumulation. Make sure to meet the permissible voltage

requirements for this device.

After switching off and before switching on you must wait for at least 5 seconds.

Note:

The screen of a data cable must always be connected with the connector housing (EMC).

Under the embedded operating system, interfaces must explicitly be enabled and required

drivers must be installed for being able to use them.

4.1 AVAILABLE INTERFACES

PC VERSION INTERBUS VERSION SERCOS VERSION

4.2 CABLE INSTALLATION

The BPC 1000 interfaces are installed in the front of the device. Install required data leads

and secure them against slipping out.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 23 24

Keine Kommentare

Ads-tec BPC1000 Bedienungsanleitung Seite 14