Ads-tec MCR5000 Bedienungsanleitung PDF herunterladen (Seite 15)

Industrial PCs MCR5000

ATTACHING THE MCR 5000 IN THE PLACE OF INSTALLATION

The MCR 5000 device is installed including the pre-installed bracket at the place of

installation by using 6 x M6 screws and must be held in place by an additional person

during installation.

Attention:

a thread depth of at least 12 and at most 15 mm inside the MCR 5000 device must be

observed. Use all six screwing points.

XAMPLE FOR INSTALLING THE MCR 5000 TO A WOODEN WALL FROM

18 MM PLYWOOD

Required installation materials (not included in the scope of delivery):

6 units of M6 x 35 Allen screw acc. to DIN 912

6 units of M6 washer for wooden constructions acc. to

DIN 440R

Note:

The screw length for each individual place of installation is determined in the following

way:

Wall thickness (18mm) + washer thickness (2 mm) + required penetration

depth (12 - 15mm) = screw length = 35 mm.

The 6 screws together with their washers will directly beneath the screw head be put

through holes drilled in the wall, screwed into the blind-rivet nuts in the MCR 5000 device,

and subsequently tightened with a torque of 5 Nm.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 39 40

Keine Kommentare

Ads-tec MCR5000 Bedienungsanleitung Seite 15